Provocative feature deletion: a syntactic model of agreement alternations in noun incorporation contexts

The relationship between noun incorporation (NI) and the agreement alternations that occur in such contexts (NI Transitivity Alternations) remains inadequately understood. Three interpretations of these alternations (Baker, Aranovich & Golluscio 2005; Mithun 1984; Rosen 1989) are shown to be undermined by foundational or mechanical issues. I propose a syntactic model, adopting Branigan's (2011) interpretation of NI as the result of “provocative” feature valuation, which triggers generation of a copy of the object that subsequently merges inside the verb. Provocation triggers a reflexive Refine operation that deletes duplicate features from chains, making them interpretable for Transfer. NI Transitivity Alternations result from variant deletion preferences exhibited during Refine. I argue that the NI contexts discussed (Generic NI, Partial NI and Double Object NI) result from different restrictions on phonetic and semantic identity in chain formation. This provides us with a consistent definition of NI Transitivity Alternations across contexts, as well as a new typology that distinguishes NI contexts, rather than incorporating languages.

Design construction and testing of a heat loop for study of fouling and its interrelationship to corrosion in heat exchanger tubes

A heat loop suitable for the study of thermal fouling and its relationship to corrosion processes was designed, constructed and tested. The design adopted was an improvement over those used by such investigators as Hopkins and the Heat Transfer Research Institute in that very low levels of fouling could be detected accurately, the heat transfer surface could be readily removed for examination and the chemistry of the environment could be carefully monitored and controlled. In addition, an indirect method of electrical heating of the heat transfer surface was employed to eliminate magnetic and electric effects which result when direct resistance heating is employed to a test section. The testing of the loop was done using a 316 stainless steel test section and a suspension of ferric oxide and water in an attempt to duplicate the results obtained by Hopkins. Two types of thermal ·fouling resistance versus time curves were obtained . (i) Asymptotic type fouling curve, similar to the fouling behaviour described by Kern and Seaton and other investigators, was the most frequent type of fouling curve obtained. Thermal fouling occurred at a steadily decreasing rate before reaching a final asymptotic value. (ii) If an asymptotically fouled tube was cooled with rapid cir- ·culation for periods up to eight hours at zero heat flux, and heating restarted, fouling recommenced at a high linear rate. The fouling results obtained were observed to be similar and 1n agreement with the fouling behaviour reported previously by Hopkins and it was possible to duplicate quite closely the previous results . This supports the contention of Hopkins that the fouling results obtained were due to a crevice corrosion process and not an artifact of that heat loop which might have caused electrical and magnetic effects influencing the fouling. The effects of Reynolds number and heat flux on the asymptotic fouling resistance have been determined. A single experiment to study the effect of oxygen concentration has been carried out. The ferric oxide concentration for most of the fouling trials was standardized at 2400 ppM and the range of Reynolds number and heat flux for the study was 11000-29500 and 89-121 KW/M², respectively.